Subpart 245.1 - GENERAL
“Mapping, charting, and geodesy property,” as used in this subpart, is defined in the clause at 252.245-7000, Government-Furnished Mapping, Charting, and Geodesy Property.
See the policy guidance at PGI 245.102-70 .
(1) Mapping, charting, and geodesy property. All Government-furnished mapping, charting, and geodesy (MC&G) property is under the control of the Director, National Geospatial Intelligence Agency.
(i) MC&G property shall not be duplicated, copied, or otherwise reproduced for purposes other than those necessary for contract performance.
(ii) Upon completion of contract performance, the contracting officer shall—
(A) Contact the Director, National Geospatial-Intelligence Agency, 7500 Geoint Drive, Springfield, VA 22150, for disposition instructions;
(B) Direct the contractor to destroy or return all Government-furnished MC&G property not consumed during contract performance; and
(C) Specify the destination and means of shipment for property to be returned to the Government.
(2) Government supply sources. When a contractor will be responsible for preparing requisitioning documentation to acquire Government-furnished property from Government supply sources, include in the contract the requirement to prepare the documentation in accordance with DoD 4000.25-1-M, Military Standard Requisitioning and Issue Procedures (MILSTRIP). Copies are available from the address cited at PGI 251.102 .
(3) Acquisition and management of industrial resources. See Subpart 237.75 for policy relating to facilities projects.
(4) Government-furnished property identification.
(i) It is DoD policy that Government-furnished property be tagged, labeled, or marked based on DoD marking standards (MIL Standard 130) or other standards, when the requiring activity determines that such items are subject to serialized item management (serially-managed items). The list of Government-furnished property subject to serialized item management will be identified in the contract in accordance with PGI 245.103-72 , Government-furnished property attachments to solicitations and awards.
(ii) Exceptions. The Contractor will not be required to tag, label, or mark—
(A) Government-furnished property that was previously tagged, labeled, or marked;
(B) Items, as determined by the head of the agency, that are to be used to support a contingency operation; or to facilitate defense against or recovery from nuclear, biological, chemical, or radiological attack;
(C) Items for which a determination and findings has been executed concluding that it is more cost effective for the Government requiring activity to assign, mark, and register the unique item identification after delivery of an item acquired from a small business concern or a commercial product acquired under FAR part 12 or part 8.
(1) The determination and findings shall be executed by—
(i) The Component Acquisition Executive for an Acquisition Category (ACAT) I program; or
(ii) The head of the contracting activity for all other programs.
(2) A copy of the executed determination and findings shall be provided to the DoD Unique Item Identification Policy Office at this address: OUSD(A&S)DPC/Program Development and Implementation, Room 3B855, 3060 Defense Pentagon, Washington, DC 20301-3060; or by facsimile to 703–602–6047.
(D) Items that are contractor-acquired property;
(E) Property under any statutory leasing authority;
(F) Property to which the Government has acquired a lien or title solely because of partial, advance, progress, or performance-based payments;
(G) Intellectual property or software; or
(H) Real property.
(5) Reporting loss of Government property. The Government-Furnished Property module of the Procurement Integrated Enterprise Environment is the DoD data repository for reporting loss of Government property in the possession of contractors. The requirements and procedures for reporting loss of Government property to the Government-Furnished Property module are set forth in the clause at 252.245-7002, Reporting Loss of Government Property, prescribed at 245.107 .
245.103-70 Furnishing Government property to contractors.
Follow the procedures at PGI 245.103-70 for furnishing Government property to contractors.
245.103-71 Transferring Government property accountability.
Follow the procedures at PGI 245.103-71 for transferring Government property accountability.
245.103-72 Government-furnished property attachments to solicitations and awards.
When performance will require the use of Government-furnished property, contracting officers shall use the fillable electronic “Requisitioned Government Furnished Property” and/or “Scheduled Government Furnished Property” formats as attachments to solicitations and awards. See PGI 245.103-72 for links to the formats and procedures for preparing Government-furnished property attachments to solicitations and awards.
245.103-73 Government property under sustainment contracts.
See PGI 245.103-73 for information on the reporting requirements for Government inventory held by contractors under sustainment contracts in accordance with DoD Manual 4140.01, Volume 6, DoD Supply Chain Materiel Management Procedures: Materiel Returns, Retention, and Disposition.
245.103-74 Contracting office responsibilities.
See PGI 245.103-74 for contracting office responsibilities.
245.104 Responsibility and liability for Government property.
In addition to the contract types listed at FAR 45.104, contractors are not held liable for loss of Government property under negotiated fixed-price contracts awarded on a basis other than submission of certified cost or pricing data.
245.105 Contractors property management system compliance.
(1) “Acceptable property management system” and “property management system” are defined in the clause at 252.245-7003 , Contractor Property Management System Administration.
(2) “Significant deficiency” is defined in the clause at 252.245-7003 , Contractor Property Management System Administration.
(b) Policy. The cognizant contracting officer, in consultation with the property administrator, shall—
(1) Determine the acceptability of the system and approve or disapprove the system; and
(2) Pursue correction of any deficiencies.
(c) In evaluating the acceptability of a contractor’s property management system, the contracting officer, in consultation with the property administrator, shall determine whether the contractor’s property management system complies with the system criteria for an acceptable property management system as prescribed in the clause at 252.245-7003 , Contractor Property Management System Administration.
(d) Disposition of findings—
(1) Reporting of findings. The property administrator shall document findings and recommendations in a report to the contracting officer. If the property administrator identifies any significant property system deficiencies, the report shall describe the deficiencies in sufficient detail to allow the contracting officer to understand the deficiencies.
(2) Initial determination. (i) The contracting officer shall review findings and recommendations and, if there are no significant deficiencies, shall promptly notify the contractor, in writing, that the contractor’s property management system is acceptable and approved; or
(ii) If the contracting officer finds that there are one or more significant deficiencies (as defined in the clause at 252.245-7003 , Contractor Property Management System Administration) due to the contractor’s failure to meet one or more of the property management system criteria in the clause at 252.245-7003 , the contracting officer shall—
(A) Promptly make an initial written determination on any significant deficiencies and notify the contractor, in writing, providing a description of each significant deficiency in sufficient detail to allow the contractor to understand the deficiency;
(B) Request the contractor to respond, in writing, to the initial determination within 30 days and;
(C) Evaluate the contractor’s response to the initial determination, in consultation with the property administrator, and make a final determination.
(3) Final determination. (i) The contracting officer shall make a final determination and notify the contractor, in writing, that—
(A) The contractor's property management system is acceptable and approved, and no significant deficiencies remain, or
(B) Significant deficiencies remain. The notice shall identify any remaining significant deficiencies, and indicate the adequacy of any proposed or completed corrective action. The contracting officer shall—
(1) Request that the contractor, within 45 days of receipt of the final determination, either correct the deficiencies or submit an acceptable corrective action plan showing milestones and actions to eliminate the deficiencies;
(2) Disapprove the system in accordance with the clause at 252.245-7003 , Contractor Property Management System Administration; and
(3) Withhold payments in accordance with the clause at 252.242-7005 , Contractor Business Systems, if the clause is included in the contract.
(ii) Follow the procedures relating to monitoring a contractor's corrective action and the correction of significant deficiencies in PGI 245.105 .
(e) System approval. The contracting officer shall promptly approve a previously disapproved property management system and notify the contractor when the contracting officer determines, in consultation with the property administrator, that there are no remaining significant deficiencies.
(f) Contracting officer notifications. The cognizant contracting officer shall promptly distribute copies of a determination to approve a system, disapprove a system and withhold payments, or approve a previously disapproved system and release withheld payments to the auditor; payment office; affected contracting officers at the buying activities; and cognizant contracting officers in contract administration activities.
245.107 Contract clauses.
(1)(i) In lieu of the prescription at FAR 45.107(d), use the clause at FAR 52.245-1, Government Property, in all purchase orders for repair, maintenance, overhaul, or modification of Government property regardless of the unit acquisition cost of the items to be repaired.
(ii) For negotiated fixed-price contracts awarded on a basis other than submission of certified cost or pricing data for which Government property is provided, use the clause at FAR 52.245-1, Government Property, without its Alternate I.
(2) Use the clause at 252.245-7000, Government-Furnished Mapping, Charting, and Geodesy Property, in solicitations and contracts when mapping, charting, and geodesy property is to be furnished.
(3) Use the clause at 252.245–7001, Tagging, Labeling, and Marking of Government-Furnished Property, in solicitations and contracts that contain the clause at FAR 52.245-1, Government Property.
(4) Use the clause at 252.245–7002, Reporting Loss of Government Property, in solicitations and contracts that contain the clause at FAR 52.245–1, Government Property.
(5) Use the clause at 252.245-7003 , Contractor Property Management System Administration, in solicitations and contracts containing the clause at FAR 52.245-1, Government Property.
(6) Use the clause at 252.245-7004 , Reporting, Reutilization, and Disposal, in solicitations and contracts that contain the clause at FAR 52.245-1, Government Property.